Remove the wiper blade assembly by holding its pivot area and pushing it in the direction shown by the arrow while depressing the wiper blade stopper. Setting the alarm-level engine speed 1. Releasing the button for 3 seconds will exit the zone setting mode. Drain out the engine oil by removing the drain plug while the engine is still warm. Each time this button is pressed, the band will change in the following order: The display indicates which one is currently selected.
The mirrors can also be adjusted manually. . Is there a fault in exhaust sys- Repair or replace Replace the rear Check exhaust system parts. Nev- er allow a child to stand up or kneel on the seat. Tighten the top tether securely.
In Compartment Light System 28. The passenger cannot protect the child from injury in a collision, because the child will be caught between the passenger and objects inside the vehicle. The horn will sound once to indicate that you are in the transmitter programming mode. Outside air : Outside air is drawn into the pas- senger compartment. Accord- ing to accident statistics, children are safer when properly restrained in the rear seating po- sitions than in the front seating positions. Is the resistance less than 10 Go to step 7. Recline the seatback rearward up to the lowest po- sition.
Put on the spare tire. Remove the mounting screws using a phillips screwdriver and then remove the high mount stop light cover. Malfunction indicator light does not come on. Replace the bulb with new one. Chapter 3: Instruments and controls This chapter informs you about the operation of instru- ment panel indicators and how to use the instruments and other switches.
The horn sounds and the turn signal lights flash if someone attempts to break into your vehicle. Never exceed the speed limit below for each gear po- sition except for brief acceleration in an emergency. Starter 5 Disconnect the connector and terminal from starter. Never drive while the parking brake is set be- cause this will cause unnecessary wear on the brake linings. Speedometer The speedometer shows the vehicle speed.
If the light is blinking:. Maintenance and service 1 Air cleaner case cover 2 Air cleaner element 2. Front Exhaust Pipe 6 Remove the nuts which hold the front exhaust pipe onto cylinder heads. Use a screwdriver to de- tach the four clips at the top and the two hooks on each side. Seatbelt maintenance To clean the seatbelts, use a mild soap and lukewarm water. Any problems caused by improper maintenance and service performed by you are not eligible for warranty coverage. Check ignition Repair open or 1 Connect the main relay connector.
Place the booster seat in the rear seating position and sit the child on it. Replace the cam- 1 Remove the camshaft position sensor. Place the jack under the side sill at the front or rear jack-up point closest to the flat tire. Avoid stopping on the road. Cylinder Head Assembly 13 Remove the cylinder head gasket. Before removing the headlight assembly. Is the voltage more than 10 V? Please leave this manual in the vehicle at the time of resale.
Push the button a second time to select this position. Pull the inside door handle to open an unlocked door. In addition, sudden application of engine brakes when the vehicle is travelling on a slip- pery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased. If clearance exceeds the clogged oil passage, worn rotor chamber, cracks, limit, replace the rotor. Towing with all wheels on the ground 1. Camshaft 13 Remove the camshaft cap. Trouble Possible cause Corrective action Cracked diaphragm or oil leakage within switch Replace.
Refer to the procedure for removing the front exhaust pipe. Valve Rocker Assembly 3 Tighten the bolts a through d to specified torque. Sit well back in the seat. Do not use the convex mirror to judge the distance of vehicles behind you when changing lanes. Remove the bulb from the headlight assembly by turning it counterclockwise. Re- move the storage compartment if so equipped.
If the same fuse blows again, this indicates that its system has a problem. Air from the foot outlets is slightly warmer than air from the instrument panel outlets. Proceed with the A temporary poor diagnosis corre- contact. When finished, carefully disconnect the cables in exactly the reverse order. Such modifications can interfere with proper operation of the seatbelt pretensioners. Insert the tongue plate into the buckle until you hear a click.