Do not rock the vehicle for more than a few minutes or damage to the transmission and tires may occur or the engine may overheat. This function will clear snow, fog and thin ice from the side rear view mirrors. An unbalanced tire and wheel assembly may result in irregular tire wear. Continued driving with this display on may cause the Service engine soon warning light to come on. For longer, trouble-free operation, keep the top of the battery clean and dry.
However, in some climates, you may need to use snow tires and chains. Move the transfer case lever through N Neutral directly to the desired position. Allow the safety belt to retract to remove any slack in the belt. The jack is only meant for changing the tire. Indicated capacity is the difference in the amount of fuel in a full tank and a tank when the fuel gauge indicates empty. Do not pile cargo higher than the seatbacks to reduce the risk of injury in a collision or sudden stop.
Press and release the control again to fully open. Ford Motor Company and Ford of Canada do not access event data recorder information without obtaining consent,. Follow the instructions in this chapter. Refer to the diagram inside the remote entry transmitter for the correct orientation of the battery. Press and hold the bottom part of the rocker switch to open the window.
Rotate the control clockwise to adjust the right mirror and rotate the control counterclockwise to adjust the left mirror. Copyright © 2005 Ford Motor Company. The lamps can be turned on or off by pushing on the lens. This condensation is normal and will clear within 45 minutes of headlamp operation. If the parking brake is fully released, but the brake warning lamp remains illuminated, the brakes may not be working properly. Simultaneously press and hold both the HomeLink and hand-held transmitter button.
Ford Motor Company shall not be responsible for any such programming changes. To lengthen the belt, turn the tongue at a right angle to the belt and pull across your lap until it reaches the buckle. The childproof locks are located on rear edge of each rear door and must be set separately for each door. To activate the heated mirrors, press the rear defrost button located on the climate control panel. Contact the manufacturer of your child seat for information about ordering a tether strap. Make sure the tongue is latched securely by pulling on it.
Do not use your vehicle for snow removal until it has been driven at least 500 miles 800 km. The passenger cannot protect the child from injury in a collision. Do not insert any other object in the power outlet as this will damage the outlet and blow the fuse. Tire Ply Composition and Material Used: Indicates the number of plies or the number of layers of rubber-coated fabric in the tire tread and sidewall. Power steering fluid reservoir 5. With pressure applied with palms and side latches squeezed down, pull downward on the entire storage bin and remove.
Removing the jumper cables Remove the jumper cables in the reverse order that they were connected. Displayed when the electrical system is not maintaining proper voltage. If the light flashes steadily or does not illuminate, have the transmission serviced soon, or damage may occur. These comments should be read and observed. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery.
To remove the floor mat, reverse the installation procedure. Push in the flasher control and all front and rear direction signals will flash. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. Ford Motor Company has not approved a slingbelt towing procedure. Route the child safety seat tether strap over the back of the seat and under the head restraint. Motor Company, Ford of Canada, and service repair facilities may, access vehicle diagnostic information through a direct connection your, vehicle when diagnosing servicing your vehicle, other modules in your vehicle — event data recorders — capable.
Pull the round knobs on each side of the extender to unlock it. Do not rock the vehicle for more than a few minutes or damage to the transmission and tires may occur or the engine may overheat. Foglamp control if equipped The headlamp control also operates the foglamps. To access this information, special equipment must be directly connected to the recording modules. To prolong the life of the wiper blades, it is highly recommended to scrape off the ice on the windshield before turning on the wipers.
Make sure the locking clip screws are loose before removing the extender. Please contact your authorized dealer for further information. Replacing exterior mounted mirror turn signal indicator lamp bulbs For bulb replacement, see your authorized dealer. Fill your engine coolant reservoir as outlined in Adding engine coolant in this section. However, in some climates, you may need to use snow tires and chains. Then, start the engine and complete the above driving cycle.